Autonomous Floor Cleaning in Shopping Malls: Results of Four Pilots

Before a shopping mall buys or rents a cleaning robot, we run a pilot on site and record real numbers: route area, time, speed, water use and every incident. Here are the results of four pilots of the Unit autonomous floor scrubber in large shopping malls — with the problems we found and how we solved them.

4shopping mall pilots
≈1,840 m²/h (≈19,800 sq ft/h)peak productivity
0.8 m/saverage speed
2 of 4pilots with zero incidents

Pilot results

SiteRouteAreaTimeProductivityIncidents
Mall AMain gallery1,403 m² (≈15,100 sq ft)49 min≈1,718 m²/h (≈18,500 sq ft/h)0
Mall BGallery loop1,190 m² (≈12,800 sq ft)46 min≈1,552 m²/h (≈16,700 sq ft/h)0
Mall CMain corridor, heavy visitor traffic1,240 m² (≈13,300 sq ft)40 min≈1,840 m²/h (≈19,800 sq ft/h)4, fixed by map tuning
Mall DFull pilot zone between two entrances1,640 m² (≈17,700 sq ft)1 h 25 min≈1,160 m²/h (≈12,500 sq ft/h)3, recommendations below

Productivity is calculated from the stopwatch: for Mall A, 1,403 m² (≈15,100 sq ft) / 49 min × 60 ≈ 1,718 m²/h (≈18,500 sq ft/h). In Mall D we also measured short routes: the main entrance zone (580 m² (≈6,200 sq ft) in 19 minutes at 0.8 m/s, about 12.5 L of water) and a fast route between two entrances (507 m² (≈5,500 sq ft) in 16 minutes at 0.9 m/s).

Why Unit is faster: routes instead of zones

Most cleaning robots are given a zone of about 300 m² (≈3,250 sq ft) and plan their own path inside it, constantly rebuilding it around people and losing orientation on reflections. Unit follows a preset route the way an experienced operator would, and uses RTLS radio-beacon navigation — like GPS indoors. That gives a steady 0.8 m/s, 3 cm accuracy near walls and predictable motion without stops. Routes can follow the logic of your building rather than the limits of the technology.

Incidents and how we solved them

Mall C — four incidents on one route

  • Three times near an easel-type sign stand: the robot paused and drove around it hesitantly. Solution: at contract start we calibrate sensors to the mall geometry in one day.
  • Once, touching a person from behind near an elevator: a limited-visibility area. Solution: the zone is marked on the map as a “caution” area with 0.5 m/s speed and warning stickers.

Mall D — three recommendations

  • Low bases of advertising boards: too close to the floor for the LiDARs to see. Solution: additional barriers around the bases.
  • Escalator entrance: a potential risk zone. Solution: additional reflectors.
  • “Wet islands” in crowded spots: the robot manoeuvres a lot and some water misses the squeegee. Solution: schedule runs for quieter hours.

Mall A — one note

On the final run the drying function was not enabled, so during pauses the robot raised the squeegee and left water behind. In normal operation drying is on and water is collected even during stops — we enable it at contract start.

Takeaway: problem spots such as sign stands, elevators and escalators do not block deployment. They need a one-time map adjustment, which is part of commissioning.

What the pilots confirmed

  • The robot really speeds up cleaning — the calculated productivity was confirmed by timing.
  • Cleaning quality is consistently high: a straight line of travel without gaps.
  • One Unit replaces 2–3 cleaners per shift on routine floor washing.

Economics

In these pilots, replacing two cleaners and giving up a rented manual scrubber saved the mall about $2,550 per month, or about $30,000 per year, with payback in under 12 months. Your numbers depend on local labor costs — we calculate them for your site.

PurchaseRentalRental with docking stationService contract
Price$25,500from $1,100/mofrom $1,330/mofrom $1,450/mo
Minimum term—6 months6 months6 months
Maintenance and consumablesBy ownerConsumables available on the marketConsumables available on the marketIncluded
Robot replacement on failureUnder warranty (1 year)——Replacement pool

All rental options include commissioning, route drawing, scheduling and basic technical support.

Next step

After a successful pilot we do a final RTLS beacon survey (about 2 hours) and put the robot into regular operation within 3 days. Want the same report for your site? Request a pilot or see Unit for shopping malls.